Maintenance
6-11
1. Open the gauge door and locate the ink trap on the rear of the
fluid pan. (Refer to Figure 6-8.)
Check Relief Air Tube
WARNING: Before starting this procedure make certain that AC
power to the printer is OFF, and the AC power and
compressed air supply to the printer are
disconnected (unplugged). Failure to follow this
warning may result in personal injury.
2. Locate the relief air tube at the middle of the gap.
3. Place paper towels underneath the drain valve, and press the
drain valve.
Figure 6-8. Relief Air Tube
Ink tank
cap
Relief ai
tube
Replenishment
ca
To Next Page
Loading...