Maintenance
6-16
If you need to do any of these:
flush the hydraulic system
install a new printer
remove contaminated ink
store the printer
Hydraulic Maintenance
Flow Charts
General Printer Fluid
Maintenance
Perform the procedures in the order shown in Figure 6-10 on page
6-18.
Figure 6-10 is a complete flow chart which covers the conditions
under which you perform the maintenance procedures.
CAUTION
: Some procedures are repeated for different
fluid types: PROCEDURE 1 for loading Ink and for loading
Make-up Fluid, for example.
Refer to Figure 6-10 for the procedure to complete in each
situation, and the page number to turn to for that particular
procedure. Refer to Table 6-5 for a list of each of the procedures
found in Figure 6-10, and where to turn in this chapter to find that
procedure.
Procedure Name
Procedure
Number
Page Number
of Flow Chart
Prime Fluid 1 6-18
Auto Flush 2 6-19
Flushing System 3 6-20
Drain Fluid 4 6-21
Flushing Viscosimeter 5 6-22
Flow Time Calibration 6 6-23
Printer Long Term Storage 7 6-24
Nozzle Drive Set-up 8 6-25
Changing new type of Ink 9 6-26
Table 6-5. Ink Maintenance Flow Charts
To Next Page
Loading...