Saturn S300 Series - Page 121

Maintenance
6-18
Procedure 1
Load Fluid into the Printe
r
WARNING: Refer to Ink Maintenance Flow
Charts on page 6-16 before
performing ink maintenance
procedures.
Start
Place fluid in the left
side replenishment
compartment; ensure
that make-up fluid is
loaded on the right
side.
Keep the print head
towards ground,
better with a
container at the down
side.
Take off the print
head cover (Figure
6-2).
Select “Prime
Fluid” in <System
Maintenance>.
Reverse the main
filter. (Ensure the
output connector
at the u
p
side
)
Turn regulator
knob clockwise to
set ink pressure at
2.6-2.8.
Return to
Figure 6-10.
“Prime Fluid” will
stop after 4
minuets.
Switch on
The power supply
Figure 6-11. Prime Fluid into the Printer (Procedure 1)