Saturn S300 Series - Page 158

Appendix 5 - User Defined Font
8-10
11. Download Font
(1) Plug the USB disk into the USB connector at the ECU
(2) Power on the printer, enter “Message Store-4”, select “User-defined Fonts”, and
then select “Download Font”. It displays as below:
(3) The Parameter zone will display all the fonts in U-disk, use “Direction Key” to
select needed font (Bolded and shine), Then, the font selected will display in the
Example Area.
(4) Use“Select/Cancel”to select font or not. Repeat the procedure to select several
font at one time.
(5) Select OK to save the font from U-disk to the printer. Enter <Message Edit>,
“Select Font”, you will find the added font, and select it directly.
Caution: The format font must be .FON, and the message should be at most
8 bits of English letters or number (Avoid saving the same files name as the exist font
in printer), or the printer can not identify it.
12. Delete Font
Use “Delete Font” to delete useless font. The procedure is as below:
Refer to Procedure 11 for operation details.
System Status:
Printer is off
2007 / 12 / 13 12:00
Saturn Technologies Co. Ltd
Current Flow Time: 4200
Ok (F1)
Exit (F3)
Download Font
Cancel (F2)
Font Size
Font Name
0709
Example
6×6
0505
0507
6×8
6×10
Saturn
System Status:
Printer is off
Saturn Technologies Co. Ltd
Current Flow Time: 4200
Ok (F1)
Exit (F3)
Delete Font
Font Size
Font Name
Example
6×8
0505A
0507B
6×8
Saturn