INK JET PRINTER OPERATION
5-6
System Status Zone
Displays the current status of the machine like “Printer is off”,
“Printer is starting up”, “Printer is shutting down”, “Printer is ready”,
“Printer is ready to print” etc.
Menu Name
Displays the menu name or function name in the current menu, such
as “Main Menu – 1” or “Insert Clock”.
Message Edit Zone
Message Edit Zone is used to edit message you want under the
“Message Edit Menu”, or check the current printing message in other
menus.
On the lower right-hand corner of Message Edit Zone, it displays
“FONT: 0507 INS CAP X: 0000 Y: 0000”, which matches to
corresponding the current edit status, “5X7 font, insert, capital, X and
Y axis of cursor.”
Caution: It could not display Message Edit Zone in some certain
menus.
Message Bar
When the length of the message is beyond the screen, it shows the
approximate position of the cursor.
Parameter Setup Zone
Displays parameter under the certain function.
Function Select Bar
Displays 3 menus or functions at most, and displays the three
functions as 3 function
ke
y label on the screen. T
he <Adjust keys> on
the both sides of <Function Select key> can roll all the optional
functions as 3 functions per group (if the number of the functions
over 3). After every rolling, the function key label will be changed. The
function of the key will be changed correspondingly to match the
label.
Fault Report Zone
Displays fault or warning messages if the printer has a fault or
warning.
It will display the faults or warnings repeatly if there are several faults
or warnings.
The warning message will be disappear until the warning status is
clear and the fault message will be displayed constantly until the fault
status has been clear in order to remind the users that the fault
occurred on the printer which need to be repaired in time. If you want
to clear the fault message, please just press <SHIFT>+ <F2>.
Caution: On the right side of “Fault Report”, it will display the ink flow
time all the time.
To Next Page
Loading...