INK JET PRINTER OPERATION
5-10
Message Edit
Clear Message
If there is a message on the “Message Edit Zone”, you can select this
function to clear the old message in order to edit a new one.
Print Message
When you have finished editing message, select “Print Message” to
confirm the content of printing.
Select Font
The normal fonts for ink jet printer as following: 5X5, 5X7, 7X9, 10X16,
12X16, 16X24 etc.
The default font is 5x7, if you want to select another font, please
follow these procedures before editing messages:
1. Enter<Message Edit-1>, select <Select Font> function, it displays
current font and character sample in the “Parameter Setup Zone”,
the example as below:
2. Use up or down <Direction Key> to change the font, and the
character sample changes after that, find the font needed.
3. Select <Ok> and the cursor changes along with the font size in
the “Message Edit Zone”.
Caution:
If the cursor coordinate on Y axis is not “0000”,
some kinds of fonts could not be selected. And it displays warning
“No enough space available, can’t select this font”.
Caution:
If you know the name of the font when you select
font, you may insert the first one or several letter of the name directly
to choose and use <Direction Key> to find the font you want.
Caution:
the size of the font shows the actual pixel.
Caution:
There are two ways to move the cursor in the
“Message Edit Zone” when editing messages.
1. Directly press <Direction Key>, and the cursor will move by the
size of current font.
2. Press <SHIFT>+<Direction Key> at the same time, and the cursor
will move by a dot.
2007 / 12 / 213 12:01
To Next Page
Loading...