Saturn S300 Series - Page 68

INK JET PRINTER OPERATION
5-16
Insert 2D Code
Caution ：2D Code can be various according to the changing of
system time and serial number.
The procedures are as follow:
1. Enter <Message-4>, it displays as below:
Select “2D Code”, it displays as below:
3. Use Up or Down <Direction key> to move the select box, setup each
parameter. Use <Adjust Key> to change Code Type and Message
Type.
4. If choose “Clock” in “Message Type” as 2D Code, select “Clock
Format (F3)” to set the format of clock. Refer to Page 5-11 for
detailed procedures.
5. If choose “Serial No.” in “Message Type” as 2D Code, select “Serial
Number Format(F3)” to set the format of serial number. Refer to 5-12
for detailed procedures.
6. If choose “String” in “Message Type” as 2D Code, type into value
and characters to form 2D code. It displays as follow: