INK JET PRINTER OPERATION
5-23
Download Message
If want to download message from U disk to the printer, you can use
the function <Download Message>. The procedures of “download
message” as below:
1. Insert the U disk which has some qualified messages into the USB
port on ECU board.
2. Enter< Message Store-2>, select <Download Message>, it displays
as below:
3. It displays all the messages saved in U disk at the “Parameter
Setup Zone” of the screen.
4. Use up or down <Direction key> to move the select box to the
message you want to download, and the message displays on the
“Message Edit Zone” of the screen.
5. Use “Select/Cancel” function to choose or cancel the message,
and the message that is chosen is in white.
6. Repeat the steps above you can select several pieces of message
and use “SHIFT+A” to select the entire message in USB memory
disc.
7. Press <OK> to confirm the settings.
Caution
：The download message in USB memory disk must be
monochromatic Bmp format. And the name of the message must be
less than 8 bits English characters or numerals.
Caution
：When downloading the message, if the name of the
message is same as message has been saved, there is a dialog box
will show up at the screen, you could select “yes” to replace the
original one “all” to replace all, “no” not to replace, “cancel” to give up
downloading or “save as” to change the name of message and then
save it.
Status:
Printer is ready
Download Messa
e
2007 / 12 / 13 12:00
Saturn Technologies Co. Ltd
Current Flow Time: 4200
OK
Exit
Message Name
CRXX
XZXX
Height
16
16
8
Width
60
324
120
SCXX
Select/Cancel
To Next Page
Loading...