INK JET PRINTER OPERATION
5-24
Upload Message
To upload the message from inkjet printer memory to USB memory
disc, you can use “Upload Message” function, the procedure as
below:
1. Connect USB memory disc to the USB port of the ECU board.
2. Enter< Message Store-2>, select <Upload Message>, it displays as
below:
3. It displays all the messages saved in USB memory disk at the
“Parameter Setup Zone” of the screen.
4. Use up or down <Direction key> to move the select box to the
message you want to download, and the message displays on the
“Message Edit Zone” of the screen.
5. Use “Select/Cancel” function to select or cancel the message.
6. Repeat the steps above you can select several pieces of message
and use “SHIFT+A” to choose the entire message in USB memory
disc.
7. Press <OK> to confirm the settings.
Caution
：When uploading the message, if the name of the
message is as the same as some message in USB memory disc, there
is a dialog box will show up at the screen, you could select “yes” to
replace the original one “all” to replace all, “no” not to replace,
“cancel” to give up uploading or “save as” to change the name of
message and then upload.
Status:
Printer is ready
Download Messa
e
2007 / 12 / 13 12:00
Saturn Technologies Co. Ltd
Message Name
CRXX
CRXX
XZXX
Height
16
16
8
Width
60
324
120
Ok
Select/Cancel
Exit
Current Flow Time: 4200
To Next Page
Loading...