INK JET PRINTER OPERATION
5-36
System Status
It is used to check the current status of the printer. This can help you
judge if the printer is normal or not. The setting procedures as below:
1. Enter <System Setup-1>, select <System Status>, it displays as
below:
2. Select <Exit> or directly press <EXIT> key on the keyboard to
quit “System Status” and go back to <System Setup-2>.
Caution
:
1. “Make-up Adding Time” means the actual time that make-up
adding valve opens.
2. “Make-up Adding Status” means if the make-up adding time is 0
of the latest 8 times viscosity measure cycle. “0” means make-up
add time is 0, “1” means make-up add time is not 0.
3. “Jet Time” means the hours after the status “Printer is ink on”.
“Running Time” means the hours after switch on the printer.
4. After switch on the printer, the “current flow time” is “target flow
time”. It will show the actual flow time of printer after the first of
viscosity measure cycle is done.
Software Version
Enter <System Maintenance-2> and press <Software Version> to
obtain the software number of the printer.
Machine ID
Each printer has a unique authorized number (machine ID), to use
this function to get the machine ID.
Status:
Printer is ready
S
stem Status
2007 / 12 / 13 12:00
Saturn Technologies Co. Ltd
Current Flow Time: 4200
Exit
Target Flow Time
Current Flow Time
4200
4178
Nozzle Drive
30
Jet Time
Best Phase
430
2
Runnin
Time
502
Make-up Add Time
26
Make-up Add Status
11010011
To Next Page
Loading...