Saturn S300 Series - Page 90

INK JET PRINTER OPERATION
5-38
Caution : When it prints continuously, you must recycle the
spout ink by a container which is made of metal and connected to the
earth. Check the quality of print sample and cleanness of the
printhead. DO NOT allow the container to accumulate a lot of ink as
this is a fire hazard.
Nozzle Drive
Nozzle Drive is one of the most important parameter which affects
print quality. Good Nozzle Drive can make you get better print quality
and keep the printer working stably for a long time. The setup
procedures as below:
1. Make sure the printer status has been “Printer is ink on” or
“Printer is ready”.
2. Enter <System Maintenance-2>, select <Nozzle Drive>, it displays
as below:
3. Use right/left <Adjust Key> to increase or decrease the setup
value or enter the value you wanted directly. The “Phase Figure”
shows how about the charge specialty.
Caution : How to set up “Nozzle Drive” correctly in detail,
please read the relative contents of Chapter 6 “System Maintenance”
in “Service Manual”.
Print Test
2007 / 12 / 13 12:00
Saturn Technologies Co. Ltd
Current Flow Time: 4200
Exit
Print Pitch
Print Status
50
Sto
p
Start / StopPrint Once
Status:
Printer is ready
Nozzle Setu
p
2007 / 12 / 26 12:00
Saturn Technologies Co. Ltd
Current Flow Time: 4200
Exit
Nozzle Drive
Print Status
CancelOk
600
350
100
(0 ~ 100)
Status:
Printer is ready