Sauer LASERTECH 40 - Page 68

Planning, transport, installation
LASERTEC 40
Page 67
Lubrication requirements
Follow instructions from the manufacturers of the peripherals!
Item Location Activity
0 X axis: 2 grease
nipples (second
grease nipple on
the other side)
apply grease
approx. 3 cm
3
0 Y-axis: 2 grease
nipples (second
grease nipple on
the other side)
apply grease
approx. 3 cm
3
0 Z axis: Grease
nipple under the
table angle
apply grease
approx. 3 cm
3
First filling
See section "Lubricants".