USING THE JUMP STARTER
The Jump Starter provides a current up to 600 amp to assist starting a car.
Check to ensure the following before connecting the booster cable clamps to the car battery:
• Ensure the ignition is off.
• Ensure all ancillary equipment (lighting, radio etc.) is switched off.
• Ensure the vehicle battery is rated at 12V and is not damaged in any way.
• Ensure the battery terminals are perfectly clean, the clamps are firm and perfectly secure.
Before using the Power Station to jump start your vehicle, please read and follow these
instructions and consult your vehicle manual.
1. Identify the polarity of the battery terminals. The battery terminal is typically marked with a
(+) symbol for the positive terminal and a (-) for the negative terminal.
2. Identify if you have a negative or positive grounded vehicle. This can be done by identifying
which battery post ( + / - ) is connected to the chassis.
6
1
2
3. For a negative grounded vehicle (most common),
connect the RED POSITIVE clamp first to the battery
terminal, then connect the BLACK NEGATIVE clamp to
the negative terminal or vehicle chassis. Note, when
disconnecting, do so in reverse sequence, removing
the negative first (or positive first for positive grounded
systems).
4. Attempt to switch on the engine of the casualty vehicle.
5. Once the engine starts running, disconnect the black clamp " - " first and return it
to its storage position. Then disconnect the red clamp " + " from the battery
terminal and restore it to its storage position. Important: If your engine doesn’t
start, wait at least 3 minutes before trying again. Do not allow the positive and negative
cables to touch during this process.
Re-charge your Power Station as soon as possible after using it as a jump starter. Please see
charging table for a representation of charging times relative to the amount of attempts for using
as a jump starter.
USING THE AIR COMPRESSOR
• Remove your tyre dust cap from the tyre valve.
• Carefully uncoil the air hose on the Power Station and attach to your vehicles tyres.
• Wait a few moments and your current air pressure will be displayed.
• Switch the “ON/OFF SWITCH” on the Power Station to “ON” and the compressor will
automatically start to inflate.
DO NOT USE CONTINUOUSLY FOR MORE THAN 10 MINUTES
• Once the desired pressure has been met, turn the “ON/OFF SWITCH” to “OFF”, then
disconnect the valve connection
• Replace any dust caps which have been removed
Not suitable for use with domestic inflatable items.
7
PRESSURE
GAUGE
ON/OFF
SWITCH
Air compressor on reverse of Power Station.
30
60
90
120
150
0
0
1
2
3
4
5
To Previous Page
Loading...