Schaltbau CT1115/04 - Mounting Holes

18
2019-03-06 / V1.0
Installation
Contactors CT/CU Series – Installation and Maintenance Instructions
Mounting holes
The mounting holes at the mounting frame or plate can
either be
- threaded holes (for threaded screws)
- or through holes (for threaded screws and nuts).
Depending on the contactor type the dimensions and
arrangements of the mounting holes are shown in
Fig. 1 to Fig. 4.
60
186.5
Mounting holes 4x Ø6.6
or 4x M6
±0.1
334.5
364
±0.15
7
46
±0.15
(bottom view)
1115/04, 1130/04
Fig. 1: CT/CU 1115/04, 1130/04: Dimensions (in mm) and
arrangement of the mounting holes
Mounting holes 4x Ø8.8
±0.1
210
377
406
±0.15
9
80
64
±0.15
(bottom view)
or 4x M8
1115/08, 1115/10/11, 1130/08, 1130/10/11
Fig. 2: CT/CU 1115/08, 1115/10/11, 1130/08, 1130/10/11:
Dimensions (in mm) and arrangement of the mount-
ing holes
Mounting holes 4x Ø11±0.1
(bottom view)
60
±0.15
327 ±0.15
80
348
11
197
or 4x M10
1215/04, 1230/04
Fig. 3: CT/CU 1215/04, 1230/04: Dimensions (in mm) and
arrangement of the mounting holes
Mounting holes 4x Ø11±0.1
(bottom view)
78
±0.15
100
397 ±0.15
419
11
214
1215/08, 1215/10/11, 1230/08, 1230/10/11
or 4x M10
Fig. 4: CT/CU 1215/08, 1215/10/11, 1230/08, 1230/10/11:
Dimensions (in mm) and arrangement of the mount-
ing holes