345
by Schnell
SUMMARIZING TABLE OF THE PROGRAMMED MAINTENANCE
Assiduity of maintenance
In case of working with one shift Days
Sem. Year
Corresponding hours for more than one shift 8 38 150 450 900 1.800
CLEANING
General outside cleaning
X
Careful cleaning of tools
X
Cleaning the straightener
X
Cleaning the cooling fan filters
X
Cleaning plates and warning lights
X
Check that the yellow lines making the working area off are visible
X
LUBRICATION
Greasing point A bending group, 2 gr=1 pump
X
Greasing point B cutting stirrup bronze busching, 4 gr=2 pumps
X
Greasing point C translation unit, 2 gr=1 pump
X
Checking reduction unit oil level
X
Replacing reduction unit oil
X*
Topping up the batcher oil level
X
Condensate drainage from air filter
X
Lubrication of the straightener
X
Mandrel and bending pin lubrication
X
MECHANICAL MAINTENANCE
Checking the mobile blade
X
Replacing the mobile blade
Checking the fixed blade
X
Replacing the fixed blade
X
Checking the bolts which secure the blades are tightened
correctly (fixed and mobile)
X
Checking the central pin
X
Checking the bending pin
X
Turn the traction and measuring wheels on their own axis
X
Checking and possible replacement of traction and measure wheels
X
Checking and possible replacement of straightening wheels
X
Checking and if necessary replacing the wire guide holes at the
mouth of the external straightener
X
Checking the state of wear of the motor brake
X
Replacing the cooling fan filters
X
ELECTRICAL MAINTENANCE
Check the connection of the traction, bending and shifting
encoder plug
X
Check the connection of the tachometric generator plug for the
traction, bending and shifting motors
X
Inspection of the safety microswitches
X
Checking the earth
X
* After the first 150 hours of operation
Note: The maintenance intervals are only suggested and refer to an average use of the machine.
To Next Page
Loading...