SCHOTT Termofrost
®
SCHOTT Termofrost
®
Page 13
Frame height in front openings changed due to installation
8. Troubleshooting and problem solving
Frame horizontals is bended apart.
Stop function can get lost and/or door scrapes to the
bottom horizontal and/or door door scrapes to the vertical
bar of the frame
outside inside
Height is bigger
than it should
Problem 3: door scrapes to the bottom horizontal
frame
Problem 1: door goes under the stop
shims
Problem 2: door scrapes to the vertical bar of the
frame because of the bending
Solution: reposition the lower and upper adapters. It is
possible to use shims to adjust the level.
To Next Page
Loading...
Need help?
General