Why does my Schrader International 7.5 & 10 HP Electric Water Pump compressor vibrate?
If the Schrader International Water Pump compressor vibrates, ensure the mounting bolts are tightened. Level the compressor so all feet touch the floor before tightening. Realign any misaligned pulleys and flywheels. Tighten any loose belts, and if the crankshaft is bent, replace it.
How to reduce excessive oil consumption in my Schrader International Water Pump?
To address excessive oil consumption in your Schrader International Water Pump, start by cleaning or replacing the air filter if it's restricted. Check for oil leaks and tighten bolts or replace gaskets as needed. If the piston rings are worn, replace them. Ensure you're using the correct oil viscosity; if not, drain and refill with the proper oil. Level the compressor if it's tilted too much, and if the cylinder is scored, replace it.
General| Brand | Schrader International |
|---|---|
| Model | 7.5 & 10 HP Electric |
| Category | Water Pump |
| Language | English |
Guidelines for electric motor bearing grease, type, and lubrication intervals.
Steps for adjusting cut-out and cut-in pressures for the unloader.
Common issues and checks for duplex unit control panel and motors.
To Next Page