To Next PageTo Next Page
Need help?Do you have a question about the Schuett Biotec Phoenix II and is the answer not in the manual?
General| Brand | Schuett Biotec |
|---|---|
| Model | Phoenix II |
| Category | Burner |
| Language | English |
Connects the burner to natural gas supply using a DVGW-tested hose.
Describes changing nozzles and connecting gas supply or cartridge adapter.
Details connecting adapters with pressure reducers and gas-safety hoses for cartridges.
Provides estimated burn times for CV 360 and C 206 cartridges.
Instructions for connecting the burner to larger gas bottles via a hose.
Guides on adjusting gas and air supply for different flame types.
Activates flame by pressing joystick center; burns until time elapses or stopped.
Activates flame by pressing the foot-switch; burns only while pressed.
Explains meanings of Red, Flashing Red/Yellow, and Flashing Red lights.
Flame activated by joystick, burns until preset time elapses or stopped.
Activates flame via foot-switch, with burn-time display or continuous activation.
Activates burner via hand/body movement in front of the sensor.
Adjusts preset burn-time using joystick, displays time in seconds/minutes.
Instructions for charging, using, and handling the device's battery.
Configures sensor to activate flame with one or two movements.
Adjusts sensor responsiveness from off to high sensitivity up to 8 cm.
Configures if the sensor should turn off the flame with a movement.
Selects the display language for the device interface.
Sets the time after which the device automatically switches off if not used.
Resets all user configurations to factory default values.
Message indicating a problem with gas supply during ignition.
Message indicating the burner head needs cleaning after flame extinguishes.
Alerts user to a hot burner head, cautioning against touching.
Indicates the burner has become too hot and automatically shut off.
Appears if sensor sensitivity is set to 'off' when selecting sensor mode.
Appears if foot-switch is not connected when selecting 'Foot' mode.
Indicates the battery voltage is low and requires charging.
Details design features for safety like low burner tube and overheating protection.
Instructions for cleaning the burner body with mild agents.
Details on removing, cleaning (dishwasher), and reattaching the burner head.
Recommendations for regular checks of seals, cables, and hoses.
Checks line/mains connections, voltage, and cable connections.
Addresses issues with gas supply, empty cartridges, or incorrect nozzle.
Guides on optimizing gas/air mixture and nozzle selection.
Troubleshooting steps for unresponsive sensors or foot-switches.
Lists adjustable burn-time range and power supply voltage.
Details working pressures and rated heat loads for different gases.
Provides gas consumption rates and physical dimensions/weight.
Outlines factory default language, operating mode, and burn-time settings.
Lists optional accessories like foot-switches and protective guards.
Details replacement burner heads, power units, and adapters.
Information on different types of hoses and adapters for gas cartridges.
Lists available gas cartridges with specifications like type, weight, and quantity.
