Schwing SP 750-18 - Cable Remote Functions; Radio Remote (Optional)

156
Short Instructions
SP 500 / 750-15 / 750-18 / 1000 / 1250 Operation Manual
Cable Remote Functions
The cable remote includes the following buttons:
A. E-Stop Button
B. Horn
C. Concrete Pump Forward
D. Stroke Limiter (+)
E. Throttle (+)
F. Concrete Pump - O󰀨
G. Stroke Limiter (-)
H. Throttle (-)
I. Concrete Pump - Reverse
J. Vibrator Auto/Manual - On/O󰀨
K. Agitator - On/O󰀨
L. Optional Accessories 1 - On/O󰀨
M. Optional Accessories 2 - On/O󰀨
ACC2ACC1
ACC2ACC1
A
B
E
H
K
C
D
G
F
I
J
L M
Radio Remote (Optional)
To use the wireless remote, remove the dummy or ca-
ble remote plug from the socket and install the receiver
plug. At the operator control panel, put the Local/Re-
mote button in the remote position. On the wireless re-
mote, unlock the E-stop button by turning it clockwise.
Press the Power ON button and then press the horn
button. If the transmitter’s signal light does not ash,
check the battery orientation.
To turn o󰀨 the transmitter, press the Power OFF button
or the E-Stop button.
Dummy Plug
Horn Button
E-stop Button
Power ON
Button
Power OFF
Button
Dummy Plug
(removed)
Wireless Remote Plug
50%
100%
Figure 6
Connecting the wireless remote