Schwing SP 750-18 - LCD Screens; Start up Screen; Engine Status Screen; Warning Messages and Symbols

44
Overview
SP 500 / 750-15 / 750-18 / 1000 / 1250 Operation Manual
LCD Screens
Start up Screen
When the ignition switch is put into the RUN position,
power will be supplied to the Operators Panel. The
Start-up screen will briey appear on the HMI LCD
screen.
Engine Status Screen
The Engine Status Screen, appears after the Start up
Screen and displays the following information:
A. Coolant Temperature
B. Engine RPMs
C. DEF Tank Level (if equipped)
D. Message Display
E. Forced Regeneration - Start (if equipped)
F. Forced Regeneration - Stop (if equipped)
G. Engine Oil Pressure
- Press
ok
to go to the Menu screen.
- Press the to go to the Pump Status Screen
40
80
0
8
16
24
32
120
8060
ok
40
DEF
°C
PSI
LOW FUEL
A
B
C
G
D
E
F
RPM
+100
On SP500/750-15 Tier 3 machines,
coolant temperature and oil pressure
are not displayed. The icons will only
appear if a high coolant temperature
or low oil pressure alarm sounds.
Warning Messages and Symbols
Engine warnings and concrete pump faults will appear
as warning symbols on the Engine Status Screen.
A. Engine Fault
B. Regeneration Fault
C. Engine Shut Down
D. Warning Message
E. Glow Plug (Wait to Start engine)
F. Horn Silence Symbol
G. E-Stop Pressed Symbol
H. IO Module to PLC Communication Loss icon
(SP500/750-15 Tier 3 engines only see “Starting
the Machine” on page 70)
40
80
0
8
16
24
32
120
LEFT E-STOP
800
ok
40
RPM
+100
DEF
°C
PSI
A
B
C
D
G E
F
H
Engine
For a complete list of engine faults, press
ok
and then
navigate to the Engine Codes Screen. For the denition
of the fault codes, please reference your Caterpillar op-
eration manual.
Concrete pump faults are listed on the Pump Codes
Screen. Reference the “Concrete Pump Error Codes”
on page 59 to cross reference the error codes.