Schwing SP 750-18 - Wireless Remote (Optional); Safe Pairing of Transmitter to Receiver

75
Operation
SP 500 / 750-15 / 750-18 / 1000 / 1250 Operation Manual
Wireless Remote (Optional)
To use the wireless remote, remove the dummy or ca-
ble remote plug from the socket and install the receiver
plug. At the operator control panel, put the Local/Re-
mote button in the remote position. On the wireless re-
mote, unlock the E-stop button by turning it clockwise.
Press the Power ON button and then press the horn
button. If the transmitter’s signal light does not ash,
check the battery orientation.
To turn o󰀨 the transmitter, press the Power OFF button
or the E-Stop button.
Dummy Plug
Horn Button
E-stop Button
Power ON
Button
Power OFF
Button
Dummy Plug
(removed)
Wireless Remote Plug
50%
100%
Figure 19
Connecting the wireless remote
Safe pairing of Transmitter to Receiver
Safe pairing is used to get a unique assignment be-
tween a single Transmitter and a single G3 Receiver.
To exchange the Transmitter and Receivers ID’s when
replacing either the Receiver or Transmitter in a system
follow the Safe Paring procedure below:
Paring PlugReceiver SocketG3 Receiver
1. Remove power to the Receiver by turning the en-
gine o󰀨.
2. Install the paring plug into the receiver socket.
Paring Plug installed in socket
3. Simultaneously press button #1 and button #3
on the Transmitter. LED#3 will light indicating the
Transmitter is ready for Safe Pairing.
1
34
2
LED#3
Button #1
Button #3
4. Re-apply power to the Receiver by putting the
ignition switch in the RUN position. (Step 4 must
be done within 10 seconds of step 3).
5. The Transmitter will conrm the download is
complete by ashing LED#3 eight times.
LED #3