Schwinn 17 Functions - Additional Features and Functions; Scan Mode; Freeze Frame Memory; Odometer Reset Function

Scan
In Scan mode, the screen cycles through DS7", MXS, AVS,
and TM modes. Each screen is displayed for about 4
seconds.
Press right button to return to Speedometer mode.
Freeze Frame Memory
Press
the left button, Freeze Frame Memory can lock the
display at the end of a ride segment. TM, DST, and AVS,
which will
be flashing, can be read at a later time by pressing
the right key. To reset the memory, press the left button; the
display will stop flashing. This is particularly useful when
crossing
the finish line of a time trial. Note: Computer must
be in either ODO, DST; MXS, AVS, or TM mode for this
function to work.
Odometer
Reset Function
The Odometer Reset Function allows
you to reenter your total distance after the
odometer has been reset to zero. In the
ODO mode, press the left button for a few
seconds until the last digit flashes. Press
the right button to adjust the number.
Press the left button to select the number.
Then the next number will start to flash.
Repeat process until all digits are reset to
desired number. After selection of last
digit, computer
will return to ODO mode.
Troubleshooting
Malfunction
No speedometer reading
Slow display response
Black Display
Display readout fades
No trip distance readout
Display shows irregular
figures
Remedy
Check alignment of magnet & sensor.
Check distance between magnet &
sensor.
Verify temperature is within operating
limits 1 30 )
Replace battery
Reseat battery
Replace battery
Reseat battery
Replace battery
Check alignment of magnet & sensor.
Check distance between magnet &
sensor.
Reseat battery
Replace battery
Reseat battery
Replace battery
PACIFICCYCLE
4902 HAMMERSLEY ROAD
MADISON, Wl 53711
www.pacific-cycle.com
For customer service inquiries:
Toll Free: (800)515-0074
customerservice@pacific-cycle.com
Made in China
www.schwinnbike.com
©2008 Pacific Cycle Inc.
17 Functions
Art No: SU17-EL-P3-GB-SCHWINN-R6