Schwinn Tone 1 Supplement

Important Handlebar Grip Replacement Supplement
Refer to the tone owner’s manual that came with your product for complete warnings and instrucons.
Parts
Included
Remove the EXISTING
handlebar grips
❶ Remove both exisng grips (1a and 1b)
by turning the le grip counter-
clockwise and the right grip clockwise.
❷ Remove both washers (2a and 2b).
❸ Loosen the hex screws (3a and 3b) on
both thumb levers.
❹ Remove the thumb levers (4a and 4b)
from the handlebar.
AachtheNEW
handlebar grips
❶ Slide the new clamps
(1a and 1b) onto each side
of the handlebar.
❷ Route the wires (2a and 2b)
into each clamp slot.
❸ Slide the thumb levers
(3a and 3b)onto each side of
the grips.
❹ Insert the new grips
(4a and 4b) completely
through the thumb levers
and clamps.
R
R
L
L
L
Thin side
faces in
Thick side
faces out
Thin sideThick side
3 mm
4 mm
5 mm
Clamps
Hex key Replacement handlebar grips
View from underside of the handlebars
Note: Discard the washers,
and exisng grips, they are
no longer needed.
Aer
Before
Rotate the left grip
clockwise and the right
grip counter-clockwise
until fully tightened.
❺ Confirm the L and R sticker
(5a and 5b) on the end of
each new grip matches the
correct side.
❻ Tighten the hex screws
(6a and 6b) on the clamps
using the 4 mm hex key.
❼ Tighten the hex screws
(7a and 7b) on the thumb
levers using the 3 mm
hex key.
R
WARNING! Grips may loosen or fracture and may cause lose of control if the grips are not replaced!
1a
1a
3a
3a
2a
4a
4a
4b
4b
5a
5b
2a
6a
6b
7a
7b
2b
1b
1b
3b
3b
2b

Schwinn Tone 1 Specifications

General

Brand	Schwinn
Model	Tone 1
Category	Scooter
Language	English