To Next PageTo Next Page
Need help?Do you have a question about the Scotsman MV Series and is the answer not in the manual?
Steps for initial unpacking and identifying required storage bins.
Inspect machine exterior and remove panels/hoses.
Installing bin legs, gasket, and securing the machine.
Checking data plate, conditions, and ventilation space.
Connecting water inlet and drain lines.
Machine start-up mode, PC board, and initial component activation.
Details the freezing cycle, including water filling and ice formation.
Details the harvest cycle, including ice release and water purge.
Explains various alarms, their causes, and reset procedures.
Diagrams illustrating refrigerant flow in freeze and harvest cycles.
Diagrams showing water system flow during freeze and harvest.
Location of key refrigerant components like compressor and condenser.
Identification of water system parts like inlet valve and pump.
Overview of PC board and sensors within the electronic system.
General| Condenser Type | Air-cooled or Water-cooled |
|---|---|
| Cooling System | Air-cooled or water-cooled |
| Dimensions | Varies by model |
| Material | Stainless steel |
| Electrical | Varies by model |
| Storage Capacity | Varies by model |
| Water Supply | Varies by model |
| Weight | Varies by model |
| Power Supply | 115V/60Hz or 230V/60Hz |
| Refrigerant | R-404A |
