ENGLISH
47 |
ROAD BIKE | OWNER’S MANUAL 2021
In the case of SRAM start by setting the cam disc on the slightly pulled and
inward moved shifters. Screw in the screw positioned behind the hood in the
body by using an Allen key (e).
In the case of flat bars there is a small adjusting bolt where the brake hose of a
side-pull brake runs into the brake lever unit or on the lever itself.
Check the proper adjustment and functioning of the brake system subsequent-
ly, as described in the chapter “Brakes” and/or in the manuals of the brake
manufacturer.
If you have problems reaching the levers, please contact your SCOTT dealer.
WARNING
Make sure you cannot pull the brake levers all the way to the handlebars (f).
Your maximum braking force must be reached short of this point!
Note that the bolted connections of the stem, handlebars and brakes have to
be tightened to the specified torques. You will find the respective values in
the chapter “Recommended torque settings for your SCOTT bike” or in the
manuals of the component manufacturers. If you disregard the prescribed
values, the components may come loose or break. This can lead to a severe
crash.
SAFETY INSTRUCTIONS
In the case of hydraulic brakes and disc brakes follow the manual of the
brake manufacturer. If you are in doubt or if you have any questions, contact
your SCOTT dealer.
Some manufacturers offer brake levers/shifters which are suitable for small
hands. If you have any problems with the brake lever reach, contact your
SCOTT dealer.
To Next Page
Loading...
Need help?
General
