SCOTT R-316 User Manual

AUDIO TEST PROCEDURE
CONTROL TEST SCALE MEASURE AT
SETTINGS EQUIPMENT SETTINGS POSITIVE PROBE NEGATIVE PROBE
READINGS TOL.
TEST INPUT
Balance Aux, Selector AC VIVM 3V Speaker A Speaker A Set output for 0 dB
Control : "Aux." mp Ng"
Left Tone Control 8 ohm load high 8 ohm load low Note 45 dB drop in +42 dB
Channel "Flat" output, right chan. _
1000 Hz Comp. Sw.
Nore"
Volume
"Maximum"
Mode Switch
ono"!
Balance CCW
Balance CW " " Note 45 dB drop in
output, left chan. 42 dB
Harmonic*! Aux. Selector AC VIVM 30V Speaker A Speaker A Adjust input for
Distortion "Aux," ue "gn output @ both chan,
20 Hz* |Mode Switch | Harmonic 8 ohm iload high 8 ohm load low R316 - 12.7V
1000 Hz "Mono" Distortion R326 - 15.5V
20,000 Hz| Balance Analyzer
*(R316 & "Center"
R326 - Volume
40 Hz) "Maximum"
0.5%
*Note: Power line Voltage 120 VAC <2.0% line THD. When transformer primary is connected for other than 120 Volts, use
appropriate supply voltage.
Damping Aux. Selector AC VTVM 3.0V Speaker A Speaker A Set output to 2,45V
Factor 1000 Hz "Aux," "yf Ng" (+10 dB)
Mode Switch 8 ohm load high 8 ohm load low
"Mono" Remove load and note
Balance increase in level
"Center"
Volume Max. O.5 dB
"Maximum"

SCOTT R-316 Specifications

General

Brand	SCOTT
Model	R-316
Category	Stereo Receiver
Language	English