CONTENT
PRECAUTIONS 1
CONTENT 2
BOX CONTENT 2
LOCATION OF CONTROLS 2
POWER SUPPLY 2
BASIC OPERATION 2
MAINTENANCE 3
TROUBLESHOOTING GUIDE 3
TECHNICAL SPECIFICATIONS 3
BOX CONTENTS
1. Unit
2. Pin for pairing
3. Instruction manual
LOCATION OF CONTROLS
RF 2.4 GHz wireless
subwoofer
1. Bass reflex tube
2. Standby/Power LEDs
(2x)
3. Speaker
4. Bass volume control
5. PAIR button
6. Crossover frequency
switch
7. PHASE switch
8. POWER ON/OFF
switch
9. AC cord
POWER SUPPLY
Connect the AC power cord to the mains with AC 100-240V ~ 50/60Hz power
source.
BASIC OPERATION
PAIRING
Pairing is to ensure your subwoofer can receive RF transmission correctly from
the docking station.
1. You have to reset the pairing first: when the docking station is in standby mode,
use the pin (supplied) to press and hold the PAIR button of the docking
station for more than 10 seconds until the source LEDS at the top of the
docking station flash for few seconds.
2. Press the PAIR button on the docking station then the PAIR button of the
other modules within one minute. All the standby LEDs will blink rapidly until
the pairing is successful in about one minute and the source LEDS at the top
of the docking station will flash for few seconds. Then the station goes into
standby mode.
Refer to the iDXS 10L or iXSW 50 manual for more information about pairing.
To Next Page
Loading...
General