Need help?Do you have a question about the SCS Industries Portable and In-Ground Spas and is the answer not in the manual?
General| Brand | SCS Industries |
|---|---|
| Model | Portable and In-Ground Spas |
| Category | Hot Tub |
| Language | English |
Do not power up your Spa until you have read this entire Operating Manual. Improper installation may result in equipment damage and void the Industries Water Tight Warranty.
Overview of the Spa's components and their locations, including the touchpad, control box, and pumps.
Description of the touchpad's functions for operating pumps, blower, temperature, and other features.
Location and function of the control box housing power supply, blower, ozone, and circulation pump connections.
Details on the main and boost pumps used for jet pressure and filtration in the spa.
Information on the circulation pump used for filtration and water circulation through the heater.
Explanation of the ozone unit for water purification and its types used in SCS spas.
Details about the heater unit, which is housed with the control box.
Purpose and location of the blower used to create bubbles via air injectors.
Description of the aromatherapy canister located on the topside for holding aroma beads.
Explanation of JetPaks as interchangeable seats offering different jetting combinations.
Information on the SCS Industries Water Tight Warranty and requirements for its activation and validity.
Important note on ensuring 500mm clearance around the spa for service access and warranty claims.
Guidance on locating the spa's serial number and identification label for service and reference.
Crucial safety guidelines for spa operation, including drug/alcohol use, temperature checks, supervision, and electrical safety.
Requirements for a solid foundation, including weight support, drainage, and specific considerations for indoor installations and decking.
Step-by-step guide for above-ground spa installation with a timber surround, including foundation preparation and leveling.
Details on timber support structures for above-ground spa installation on concrete slabs, focusing on seat and base support.
Instructions for in-ground spa installation, including excavation, concrete pouring, leveling, and backfilling.
Specific procedures for installing spas on sloping sites, including brick wall construction and drainage considerations.
Diagram illustrating the plumbing configuration for a single-pump spa system.
Diagram showing the plumbing setup for a two-pump spa system, including a boost pump.
Guidance on mounting the blower at least 450mm above water level to prevent water entry.
Recommendation for installing a one-way valve in the suction line to maintain pump prime.
Advice to minimize bends and elbows in pipework to maintain water pressure to jets.
Essential requirements for spa electrical connections, emphasizing licensed electricians, dedicated circuits, and safety switches.
Specific instructions for electricians regarding cable entry, conduit, and avoiding pressure on power cords.
Information on electric controllers, terminal blocks, and engine bay access for connecting power to the spa.
Details on the Balboa Touchpad Control Centre and its instruction sheet for operating spa functions and settings.
A pre-fill checklist to prevent damage, including inspecting service panels, barrel unions, and drain valves.
Instructions to check barrel unions on pumps and heaters for tightness before startup, noting they are not a warranty item.
Ensuring the external drain/fill valve is closed and the drain cap is tight before filling the spa.
To Next Page