Scully 280 Series - Page 7

SEe Tl O=- 2
,,"
'I' "\ \
,\ I, I ' 1
"
Side ViE'"
2.1. UNPACKING
,
•
,
•
.'
'.
•
The I4pe trarlllport and amplifier are
regularly shipped in two ca r lOrlll. The tll;O fly-
wl>eeia. pow.r cord (plug tn), EIA eenlen
(Scully, If ordered), mounUng II:I.rdware. Allen
II;rencl>ea, and alignment tool are located in a
ha.rd",are bag , which ",til be found In the carlon
COllIa!nlng the lransport me<:han1.Sm . An In-
struction n,anual !s also contained tn the ahip-
ping carton.
2.2. MOUII"TII'<G
The 280 is designed to fit In a standard
19_1nch equipment nck. cabtnet o r conSOle.
The space requirement Is IS_' 4" for llIe tape
transport and 3_1 2" fo r the arTlJlllfier. each
unit extenl1i[l5: 9" behind the panel. lbe reeom_
mended rack placement ts fo r the ampllfte r to
be mounted directly below the tape transport.
or wlth!n limit of the four-foot connectlnc
cables.
\
\
' '
,
)\0 "
•
\
.- - -
000
0
VIew
<.2. 1. Ib.cl< Mountl"
,
" ,
0
,
a . Lift tbe tran'port med>anlsm:Nt of
the cartOn 1.151" tile t wo /lhipp1rc straps hoped
around it fo r this purpose. Remove straps.
b. Mount the transport !n \he <Quip_
ment rac k. usLre tlw panel mounting hardware
T ighten secl.ln l y.
c. Remove flywheels from hardwaN!
tag and- mou"t on the rUPI!ctlve capstan motor
and st abilizer shart •. In IIOme cases tho lIy_
wlwels are spec!flcally manced for capstan Or
rt:>.b1Uu r mountLre.
Flywheels which carry 00
na r kirc' an Ln te r cllareeable and may be lI".ount _
ed on either sh2ft.
d. Remove ampllfler(s) from carton
and moUnt In nck below the tape transport.
using the mountl"l ha rdwa.." osuppUed. In MuIU_
manel mount cllannell amplifier on top.
Then mount .."malnt"l ampUflers below In
numerical oroer. AmpUfler cllannel maIklncs
nay be found on t he rear 01 each amplifier .