Operation & Maintenance Manual──LG946L Wheel Loader
21
z Slow the speed and sound the horn if necessary to let others know, and determine the proper
direction when the visibility is bad or at a narrow crossing.
z Sand, dust, fog or storm may affect the visibility. Slow down when visibility is poor. When
visibility is not good, stop working until the weather cleans.
z The loader is a special vehicle. Drive carefully when taking long parts which may block the
visibility. Carefully lift, go forward and backward,
and shift gears. Never let unauthorized people go
into the working area or give specific directions.
z There may be some illusion about the height of the
ground and the distance at night, so keep the light on
and drive at proper speed.
z Keep the front and rear head light and working light
on when working in dark areas.
5.6 Pay Attention to Blockages
z If there are blockages (roof of buildings or the door frame), keep the loader away from the
blockages when turning or passing.
z Notice the environment. Slow down and check whether there are some blockages when
turning or going through a narrow passageway.
z Operate carefully to prevent unstable loads when the ground is uneven and the load is not
stable.
5.7 Driving in Dangerous Conditions
z Do not operate when you are unsure about the environment. Investigate the condition of the
road, the strength of the bridge, landform of the
working area and all geologic features before
working.
z Pay attention to the depth that the tires sink and the
braking effect on muddy or soft ground.
z When working in water or swampland, prevent the
bottom of the axle housing from being soaked. Slow
down after passing through water or during rain. Step
on the brake pedal gently and alternately to let the
skid device dry after working in water or in rain.
z The clay piled on the ground or near the canal is
To Next Page
Loading...
Need help?
General
