Operation & Maintenance Manual──LG946L Wheel Loader
31
z When jacking up the frame, do not let anyone enter the other side of the frame.
z Before jacking up, lock the front and rear frames with a safety bar and put all the levers in
the middle and wedge the tire from the opposite side. Put the cushion blocks under the
machine.
8.4 Working under the Machine
z Park the machine on firm ground. Lower the working equipment to the ground before
working under the machine.
z Wedge the tire firmly.
z It is dangerous to work under the machine only using
the working equipment to support the machine.
z Never work under the machine without good
support.
8.5 Working on the Machine
z Make sure the top of the machine has no blockage and is clean when working on the top of
the machine. Follow the rules below:
△
! NOTICE
z Do not allow lubricant or grease to leak.
z Do not randomly put the tools around the work place.
z Walk slowly and carefully.
z Never jump down from the machine. When climbing up and down the machine, face the
machine and keep three points contact (two hands-one foot or two feet-one hand) with the
handrails and pedals to ensure safety.
z Use protective equipment if necessary.
z Never stand on the top of the engine hood because it is slippery and dangerous.
z Never stand on the top of tires because they are slippery and dangerous.
z Stand on the mudguard of the front frame and seize the handrail to clean the front glass of
the operator cab.
To Next Page
Loading...
Need help?
General
