EasyManuals Logo

SDLG LG946L User Manual

SDLG LG946L
109 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #68 background imageLoading...
Page #68 background image
Operation & Maintenance Manual──LG946L Wheel Loader
65
and brake drum. Once they are overheating, find the reason and repair it.
z Check the fastening conditions of the bolts and nuts.
Do the following maintenance after 10 hours of run-in time on the new loader:
z Check the fastening status of bolts and nuts of all parts, but especially the bolts of diesel
engine cylinder cover, vent-pipe bolts, front and rear frame bolts, rim bolts, transmission
axle bolts and connection bolts.
z Clean the raw and essential engine oil filter and fuel filter.
z Check the tension status of the belts of fan, electrical machine and air condition compressor
z Check the capacity of the storage battery electrolyte and its reserves, and fasten the connect
poles.
z Check the oil level of the gearbox. Please refer to 3.6.3 Adding Oil to Gearbox, page 87, in
this chapter.
z Check the seal of the hydraulic system and braking system.
z Check the connection and sensitivity of all control levers.
z Check the temperature and the connections of the circuit system, the power supply of
electrical machine, gauge, light and lamps and turning signals.
z Open the air storage tank to drain water.
The following maintenance should be done after the run-in period of new machine:
z Clean the filter at the bottom of the gearbox and the oil filter cartridge of the torque
converter.
z Clean the oil returning filter cartridge of the hydraulic oil tank.
z Change the engine oil. Please refer to 3.6.1 Fuel Supplying of Engine, page 83, in this
chapter.
3 OPERATION AND USE OF LOADER
3.1 Notices for Usage
z The diesel must be cleaned and deposited more than 72 hours before it is to be used. The
trademark should suit the rules.
z Transmission oil for the gearbox, torque converter, and the hydraulic oil for hydraulic
system must be clean.
z The loader must be maintained and lubricated periodically.
z Drive the loader until the brake pressure reaches 0.4MPa after the engine starts.
z Put some hot water or vapor in front of the engine for preheating it. Preheat the engine

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the SDLG LG946L and is the answer not in the manual?

SDLG LG946L Specifications

General IconGeneral
BrandSDLG
ModelLG946L
CategoryCompact Loader
LanguageEnglish

Related product manuals