WARNING
If any gasoline leak and/or odor are
present, do not start the engine.
Have the watercraft serviced by an
authorized Sea-Doo dealer.
Inspect muffler, battery, fuel tank and
oil reservoir fastening devices. Visual-
ly check electrical connections for cor-
rosion and tightness.
Inspect hull and jet pump water intake
grate for damage. Replace or have
damaged parts repaired.
Reinstall engine cover and relatch
properly.
Cleaning
The bilge should be cleaned by an
authorized Sea-Doo dealer to remove
any fuel/oil/electrolyte deposits and
mildew.
Occasionally, wash the body with wa-
ter and soap (only use mild detergent).
Remove any marine organisms from
engine and/or hull. Apply non-abrasive
wax such as silicone wax.
CAUTION:
Never clean fiberglass
andplasticpartswithstrongdeter-
gent, degreasing agent, paint thin-
ner, acetone, etc.
To clean the engine cover and the
steering pole nose and top pieces,
use only flannel cloths or an equiva
-
lent.
1
F22L0H0
1. Engine cover, steering pole nose
and top pieces
CAUTION:
It is necessary to use
flannel cloths or an equivalent on
engine cover, steering pole nose
and top to avoid further damaging
the surfaces to clean.
To remove scratches on engine cover,
steering pole nose or top pieces, use
BOMBARDIER* Scratch Remover Kit
(P/N 861 774 800).
NOTE: Be aware that when using any
scratch remover product, the part fin-
ish will turn to a dull appearance.
CAUTION:
Never clean plastic
parts or engine cover with strong
detergent, degreasing agent, paint
thinner, acetone, products contain-
ing chlorine, etc.
To clean the carpets, use 3M™ Citrus
Base Cleaner (24 oz spay can) or the
equivalent.
Stains may be removed from seat and
fiberglass with Knight’s Spray-Nine
†
from Korkay System Ltd or the equiv-
alent.
Respect the environment by ensuring
fuel, oil or cleaning solutions do not
drain into the waterways.
_____________________
83
To Next Page
Loading...
Need help?
General