EasyManuals Logo

Sea-doo GTS Series User Manual

Sea-doo GTS Series
176 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #101 background imageLoading...
Page #101 background image
SPECIAL PROCEDURES
Jet Pump Water Intake and
Impeller Cleaning
WARNING
Keep away from intake grate while
engine is running. Items such as
long hair, loose clothing or per-
sonal flotation device straps can
become entangled in moving
parts.
Weeds, shells or debris can get caught
on the intake grate, drive shaft and/or
impeller. A clogged water intake may
cause troubles such as:
Cavitation: Engine speed is high
but watercraft moves slowly due to
reduced jet thrust, jet pump compo-
nents may be damaged.
Overheating: Since the jet pump
operation controls the flow of wa-
ter to cool the exhaust system, a
cloggedintakewillcausetheengine
to overheat and damage engine in-
ternal components.
A weed clogged area canbe cleaned as
follows:
WARNING
If it is necessary to reach in to re-
move any foreign object caught in
the propulsion system, the tether
cord MUST BE REMOVED from the
engine cut-off switch
In-Water Cleaning
Rock the watercraft several times
while repeatedly pressing engine
START/STOP button for short periods
without starting the engine. Most of
the time, this will remove the block-
age. Start engine and make sure wa-
tercraft operates properly.
Iftheaforementionedmethoddoes
not work, the following can be per-
formed:
With engine running and before ap-
plying throttle, pull the iBR lever in
to select reverse operation and vary
throttle quickly several times.
Repeat procedure if necessary.
If system is still blocked, move the wa-
tercraft out of the water for cleaning.
Refer to
ON-BEACH WATER CLEAN-
ING
.
On-Beach Water Cleaning
WARNING
The tether cord MUST BE RE-
MOVED from the engine cut-off
switch to prevent accidental en-
gine starting before cleaning the
propulsion system components.
Place a cardboard or a carpet beside
the watercraft to prevent scratching
when turning the watercraft for clean-
ing.
Rotate the watercraft to any side for
cleaning.
smo2009-002-300_a
TYPICAL
Clean the water intake area. If the sys-
tem is still clogged, refer to an autho-
rized Sea-Doo dealer for se
rvicing.
_______________
99

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sea-doo GTS Series and is the answer not in the manual?

Sea-doo GTS Series Specifications

General IconGeneral
ManufacturerSea-Doo
TypeRecreational
Fuel TypeGasoline
CategoryPersonal Watercraft
Engine ConfigurationInline
Seating Capacity3
Storage Capacity26.4 gallons

Related product manuals