MAINTENANCE SCHEDULE
FIRST25HOURSOR3MONTHS
EVERY 50 HOURS OR 6 MONTHS
EVERY 100 HOURS OR 1 YEAR
EVERY 200 HOURS OR 2 YEARS
A: ADJUST
C: CLEAN
I: INSPECT
L: LUBRICATE
R: REPLACE
O: OPERATOR
D: DEALER
TO BE PERFORMED BY
PART/TASK NOTE
HULL AND BODY
Hull I O
Ride plate and water intake grate I O
—
NOTE 1: The iTC and iBR levers should be inspected by depressing and releasing t
he levers to check for
freedom of movement. If any friction is felt, the lever must be taken apart, cleaned, inspected
for wear and lubricated, refer to
INTELLIGENT THROTTLE CONTROL (ITC)
,
STEERING
and
O.T.A.S.
subsections.
NOTE 2: Ensure proper torque of iBR U arm to iBR actuator shaft retaining screws. If retaining screws found
loose, do not re-torque them. Replace them with new ones.
______________
109
To Next Page
Loading...
Need help?
General
