INFORMATION CENTER (GAUGES) (GTI/GTR/WAKE)
NOTE: The fuel consumption value
selected will be displayed in the nu-
merical display. Double click the SET
button to reset the average fuel con-
sumption indication. The display will
momentarily indicate zero (0).
VTS Mode
TheVTSMODEfunctionisusedto
manually set the VTS or change VTS
PRESET settings.
Refer to
OPERATING INSTRUCTIONS
subsection for detailed instructions.
Display
The DISPLAY function is used to
change the indication in the numerical
display. Refer to
CHANGING NUMER-
ICAL DISPLAY INDICATION
.
Fault Codes
The FAULT CODES function is used to
display active fault codes.
Refer to
MONITORING SYSTEM
sub-
section for details.
Key Mode
The KEY MODE function is used for
changing LEARNING key settings.
Refer to
OPERATING MODES
subsec-
tion for detailed instructions.
Settings
The SETTINGS function is used for:
– Changing the clock setting, refer to
MULTIFUNCTION GAUGE SETUP
.
– Activating the iBR override function,
refer to
SPECIAL PROCEDURES
.
Changing Numerical
Display Indication
To change the indication in the numeri-
cal display, carry out the following:
1. Press the MODE button on the RH
handlebar repeatedly until DISPLAY
is visible in the multifunction display.
MESSAGE DISPLAYED
DISPLAY
2. Press the SET button to enter the
DISPLAY function.
3. Press the UP/DOWN button until
the preferred indication is visible in
the multifunction display (as appli-
cable to model).
–RPM
– SPEED
–CLOCK
–ENGINETEMP
– ALTITUDE
– TOP SPEED
– AVG SPEED
–TOPRPM
–AVGRPM.
1
2
NUMERICAL DISPLAY SELECTION
1. Type of selected numerical display
indication
2. Applicable value
4. Press the SET button to select and
save the preferred indication, or
wait for the display function to time
out. The last indication visible will
be automatically saved.
62
______________
To Next Page
Loading...
Need help?
General
