Sea-doo SWITCH 13 FT 2022 - Operating Instructions; Pre-Ride Inspection Reminder; Boarding the Watercraft Safely; iBR Gate Safety Awareness

101
SSeettttiinnggss
Use the RIGHT arrow button or LEFT
arrow button to navigate through set-
ting menus. Use OK button to enter
setting menu, to confirm selection or
reset some values. Use UP arrow or
DOWN arrow to change selected
value.
MMaaiinntteennaannccee RReesseett
Select RREESS MMAAIINNTT and hold OK but-
ton to reset maintenance.
NNOOTTEE::
The maintenance reset can only be
done within the first 15 seconds of
ECM wake-up when a maintenance is
required.
DDiissppllaayy CCooddeess
Refer to Displaying Fault Codes .
SSeettttiinngg TTrriippmmeetteerr
Select TTRRIIPP and press UP or DOWN
arrow button to cycle through VVeehhiiccllee
HHoouurrss, TTrriipp KKMM and TTrriipp HHRR.
Press and hold OK button to reset se-
lected trip info.
SSeettttiinngg LLeeaarrnniinngg KKeeyy
Connect a normal key to the vehicle.
Select LL--KKEEYY ## and press UP or
DOWN arrow button to set the desired
learning key level between 1 and 5.
Press and hold OK button to confirm.
NNOOTTEE::
The default learning key level is 1
(lowest performance).
UUnniitt SSeelleeccttiioonn
Select UUNNIITTSS and press UP or
DOWN arrow button to change units.
NNOOTTEE::
Changing units will apply to all the dis-
played units.
SSeettttiinngg BBrriigghhttnneessss
Select BBRRIIGGHHTTNNEESSSS and press UP
or DOWN arrow button to adjust
brightness level (from -4 to 4).
SSeettttiinngg CClloocckk
Select CCLLOOCCKK.
1. Press OK button to select clock
display.
2. Press UP or DOWN arrow button
to select 12:00 AM PM or 24:00
time base.
3. Press OK button to confirm.
4. Press UP or DOWN arrow button
to change hours.
5. Press OK button to confirm.
NNOOTTEE::
Menu available only if GPS is
synchronized.
To exit SSEETTTTIINNGGSS, select EEXXIITT and
press OK button.
RReesseettttiinngg SSppeeeedd SSttaattiissttiiccss ((IIff
EEqquuiippppeedd))
Select SSPPEEEEDD SSTTAATT and press and
hold OK button to reset the speed
statistics.
NNOOTTEE::
The speed statistics are automatically
reset after the gauge shut down.
SSeettttiinngg LLaanngguuaaggee
The language of the display is factory
setup by default in English. Refer to
an authorized Sea-Doo dealer for lan-
guage availability and to setup the
gauge to your preference.
4.5" DIGITAL DISPLAY