147
1. Make sure the engine access pan-
el is correctly installed before lock-
ing it in position.
2. Turn the latch to lock the cover. It
may require some force to do so.
3. Make sure the latch handles are
flat on the cover when not in use.
AAuuttoommaattiicc FFiirree EExxttiinngguuiisshheerr
((IIff EEqquuiippppeedd))
The automatic fire extinguisher is lo-
cated in the engine compartment.
VVeerriiffyyiinngg tthhee AAuuttoommaattiicc
EExxttiinngguuiisshheerr
1. Remove engine access panels.
Refer to
Opening the Engine Ac-
cess Panels
.
2. Make sure that the pointer of the
pressure gauge is in the green
zone at 21 °C (70 °F).
3. Inspect the actuator and make
sure that the fire extinguisher is
charged.
CCHHAARRGGEEDD AACCTTUUAATTOORR
DDIISSCCHHAARRGGEEDD AACCTTUUAATTOORR
4. Ensure the maintenance informa-
tion recorded on the unit tag and
the maintenance table are the
same. Refer to
Automatic Fire Ex-
tinguisher Maintenance Record
.
If the above requirements are not
met, the automatic fire extin-
guisher shall be restored to a serv-
iceable condition. Refer to
Servicing the Automatic Fire
Extinguisher
.
RReemmoovviinngg tthhee FFiirree EExxttiinngguuiisshheerr
1. Remove engine access panels.
Refer to
Opening the Engine Ac-
cess Panels
.
MAINTENANCE PROCEDURES
To Next Page
Loading...
