EasyManua.ls Logo

Sea-doo SWITCH 16 2024 - Page 188

Sea-doo SWITCH 16 2024
252 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
186
BBRRPP AAUUDDIIOO SSYYSSTTEEMM
This equipment has been tested and
found to comply with the limits for a
Class B digital device, pursuant to
Part 15 of the FCC rules. These limits
are designed to provide reasonable
protection against harmful interfer-
ence in a residential installation.
This equipment generates, uses, and
can radiate radio frequency energy
and, if not installed and used in ac-
cordance with the instructions, may
cause harmful interference to radio
communications. However, this is no
guaranty that interference will occur in
a particular installation.
If this equipment does cause harmful
interference to radio or television re-
ception, which can be determined by
turning the equipment off or on, you
are encouraged to try to correct the in-
terference by one or more of the fol-
lowing measure:
Reorient or relocate the receiving
antenna.
Increase the separation between
the equipment and receiver.
Connect the equipment to an out-
let on a different circuit than the
one to which the receiver is
connected.
Consult the dealer or an experi-
enced radio/TV technician for help.
Changes or modifications not ex-
pressly approved by Mitek Corpora-
tion could void the user's authority to
operate this equipment. This device
complies with Part 15 of the FCC
rules.
Operation is subject to the following
two conditions:
(1) This device may not cause
harmful interference, and
(2) This device must accept any in-
terference received, including in-
terference that may cause
undesired operation.
IC Registration Number:
22793-278003465
FCC ID: 2AAOY - 278003465
L’émetteur/ récepteur exempt de li-
cence contenu dans le présent appa-
reil est conforme aux CNR
d’Innovation, Sciences et Développe-
ment économique Canada applica-
bles aux appareils radio exempts de
licence. L’exploitation est autorisée
aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de
brouillage;
(2) l'appareil doit accepter tout brouil-
lage radioélectrique subi, même si le
brouillage est susceptible d'en com-
promettre le fonctionnement.
Radio Equipment Directive (RED)
2014/53/EU and Harmonized
Standards:
ETSI EN 300 328 V2.1.1
(2016-11)
ETSI EN301 489-1 V2.1.1
(2017-02)
ETSI EN301 489-17 V3.1.1
(2017-02)
EN 62479:2010

Related product manuals