SAFETY INFORMATION 77
IITTEEMM OOPPEERRAATTIIOONN
Integrated Automatic Fire Extinguisher
(if equipped)
– Check the pressure gauge
and ensure the pointer lies
within the green zone. Refer
to
Verifying the Automatic
Extinguisher
.
– Verify the indicator light is
on. Refer to
Automatic Fire
Extinguisher
in
EQUIPMENT
section.
Sacrificial anodes
Inspect every month (more
often in saltwater use) and
change if necessary.
HHuullll
Inspect hull for cracks, loose screws and other damages.
Properly clean the hull before launching the watercraft when moving to a different
water plan to prevent from spreading aquatic invasive species. Refer to
What to
Do After Leaving the Water
at the end of this section.
PPoonnttoooonn FFllooaattss
Inspect the pontoon floats for cracks.
Properly clean the outside and inside of the floats using the rinsing system before
launching the watercraft when moving to a different water plan to prevent from
aquatic invasive species. Refer to
What to Do After Leaving the Water
at the end
of this section.
JJeett PPuummpp WWaatteerr IInnttaakkee
Remove weeds, shells, debris or anything else that could restrict the flow of
water and damage the propulsion unit. Clean as necessary. If any obstruction
cannot be removed, refer to an authorized
Sea-Doo
dealer for servicing.
PRE-RIDE INSPECTION
To Next Page
Loading...
