38
PRE-OPERATION CHECKS
Some of the following items may not have been previously covered in this guide,
however they will be described in the MAINTENANCE or SPECIAL PROCE-
DURES section. Please refer to these portions to have more detailed information.
Prior to operating the craft, verify the following:
SUMMARY
WARNING
The pre-operation check is very important prior to operating the vehicle.
Always check the proper operation of critical controls, safety features and
mechanical components before starting. If not done as specified here, se-
vere injury or death might occur. Bring all safety equipment required by
local laws.
WARNING
Engine should be off and the safety lanyard must always be removed from
its switch prior to verifying any of the following. Only start craft once all
items have been checked and operate properly.
ITEM OPERATION ✓
Safety lanyard ignition switch Check operation.
Hull Inspect.
Jet pump water intake Inspect/clean.
Bilge Drain. Ensure plug is secured.
Battery Inspect tightness of cables and retaining straps.
Main battery cut-off switch Ensure it is in the ON position.
Navigation lights Check operation.
Fuel tank and oil reservoirs Refill.
Engine compartment Verify fuel/oil system components.
Steering Check operation.
Throttle/shift lever system Check operation.
Bilge blower and bilge pump Check operation.
Mandatory safety boating
equipment
Check operation.
Storage compartment covers and
engine cover
Ensure they are closed and latched.
lmo2001-004a.book Page 38 Friday, November 3, 2000 3:27 PM
To Next Page
Loading...
Need help?
General
