51
Periodic Inspection Chart
NOTE: Some items are included in the PRE-OPERATION CHECKS and are not
necessarily mentioned in this chart but must also be done. Refer to M
2
Jet Drive
Operator‘s Guide for engine and jet pump checks.
➀ Every 10 hours in salt water use.
➁ Daily flushing in salt water or foul water use.
DESCRIPTION
FREQUENCY
FIRST
10 HOURS
EVERY
25 HOURS
EVERY
50 HOURS
EVERY
100 HOURS OR
SEASONALLY
TO B E
PERFORMED
BY
Lubrication/corrosion protection ✓ OPERATOR
Lubrication of locks ➀✓ OPERATOR
Safety lanyard cap ✓ DEALER
Throttle/shift lever cables
operation/lubrication
➀✓ OPERATOR
Throttle/shift lever cables adjustments ✓ DEALER
Fuel filter inspection ✓ DEALER
Fuel filter replacement ✓ DEALER
Steering system and low-speed steering
control system
✓ DEALER
Throttle/shifter system ✓ DEALER
Muffler, battery and reservoir fastening
devices
✓ DEALER
Fuel/oil line, hose inspection ✓✓✓✓ DEALER
Bilge pump/deck drain/scupper valve
inspection
✓ OPERATOR
Battery condition ✓ DEALER
Starter cables ✓ DEALER
Monitoring beeper/electrical connections ✓ DEALER
Hull condition and ride shoes ✓ DEALER
Cooling system flushing
➁ ✓ OPERATOR
Navigation lights condition ✓ DEALER
Sacrificial aluminum anode(s) ✓ OPERATOR
Bilge blower inspection ✓ DEALER
lmo2001-004a.book Page 51 Friday, November 3, 2000 3:27 PM