GM9 Quick Start Manual
SD-MA-032 V01
Note
1. Do not fix the device to any surface which is a heat source to avoid over heating
2. Do not cover the surface or ventilation grills of the device to avoid over heating
1. Verify the package contents
Please verify the package contents against the list below
1. GM9 Controller 1
2. Power Adapter 1
3. Ethernet Cable 1
4. GM9 Quick Start Manual 1
5. RS232 RJ45 to Serial Port Cable 1
6. Download Guide Card 1
If any of the items in the packing list are missing, please contact your reseller.
2. Set up the GM9
Power up the GM9 controller and connect the input and outputs to correct devices.
1 – Power Switch 4 – HDMI Input 7 – Ethernet RJ45 Port
2 – Power Connector 5 – USB 3.0 Ports 8 - Dipswitches
3 – HDMI Outputs 6 – RS232 RJ45 Port 9 – RCA Audio Output
Figure 1
3. Connect through IP in ‘Device’
The default IP address for GM9 controller is 192.168.1.236. Users need to change the IP address of
control PC to the same IP group of GM9.
• Change the ‘Obtain an IP address automatically’ to ‘Use the following IP address’ to set up a static
IP address of TCP/IPv4 in Ethernet Properties
➢ IP address: any address between 192.168.1.2 and 192.168.1.253 except the address
which has been taken by the GM9
➢ Subnet mask: 255.255.255.0, Default Gateway: 192.168.1.254
• Once the control PC IP address having been set up, connect PC to the LAN RJ45 port of the GM9
controllers via a network cable and then press the button (or Connection -> Player
Connection Settings) and wait for the scan to complete. Select the device and press
connect
To Next Page
Need help?
General
