Seagull 1963 User Manual

To set the time:! Pull out the crown from position 1 to 2. Rotate the crown until you
! ! ! reach the desired time. Turn hands clockwise only.
To wind:! ! Rotate the crown in the 1 position clockwise until you feel
! ! ! resistance. Then stop. Do not overwind. Wind daily for keeping
! ! ! accurate time. Watch will run about 40 hours on a full wind.
30 minute timer:! Click down on pusher A to start the 30 minute stopwatch function.
! ! ! Click down again to stop and measure.
Reset timer:!! Click down on pusher B to reset the chronograph seconds hand
! ! ! and the 30 minute sub-dial back to zero.
!!!NOTE: ONLY RESET TIMER WHEN STOPPED.!
!!!A"emp&ng)to)reset)the)&mer)while)it)is)running)will)result)in)
) ) ) damage)not)covered)under)warranty.!Always!stop!the!-mer!by!
! ! ! clicking!pusher!A!before!you!reset!the!stopwatch!func-on.
SEAGULL 1963 Chronograph Operating Instructions

Seagull 1963 Specifications

General

Movement	ST19
Case Diameter	38mm
Case Material	Stainless Steel
Lug Width	18mm
Water Resistance	30 meters
Strap	Leather
Movement Type	Manual winding
Dial	Chronograph
Functions	Chronograph

Summary

Seagull 1963 Chronograph Operating Instructions

Setting the Time

Pull crown to position 2. Rotate clockwise to set desired time. Return crown to position 1.

Winding the Watch

Rotate crown clockwise in position 1 until resistance. Wind daily for ~40 hours of power.

Operating the 30-Minute Timer

Press pusher A to start the 30-minute stopwatch. Press again to stop and measure.

Resetting the Timer

Press pusher B to reset the chronograph seconds hand and 30-minute sub-dial to zero.

Timer Reset Warning

Important: Only reset the timer when stopped. Attempting to reset while running may cause damage.