2. INTRODUCTION
Handheld rechargeable inspection lamp with a high Colour Rendering Index (CRI) suitable for accurate colour matching. The light produced
by the COB LED is ideal for detecting swirls and differences in paint colour when touching up areas of bodywork. Fitted with a patented
magnetic 360° swivel base and hanging hook for hands-free operation. Supplied with USB lead and mains charger.
3. SPECIFICATION
Model no: ............................................................LED360CM
Battery: ........................................................ 3.7V - 2600mAh
LED quantity: .............................................. 10 SMD + 1 LED
Lumen output: ......................................low 200lm/high 400lm
Operating time: .......................................low 4.5hr/high 2.5hr
Charging time: ...................................................................4hr
CRI Rating: ........................................................................ 95
V IMPORTANT WARRANTY INFORMATION
The battery tted to this lamp is considered to be a consumable item and its ability to accept a charge will reduce over time.
We will provide warranty against mechanical and electrical defect for a period of one year - this does not cover fair wear and tear.
If the battery is not properly charged before rst use, or regularly conditioned, its capacity will diminish. Under these circumstances
we will not replace the battery regardless of whether it is less than one year old.
Note: The lithium battery does not suffer from memory effect and once fully charged may be stored for up to six months without
another charge.
4. OPERATION
4.1. Connect the USB lead to the charger unit and the socket on the rear of the lamp. Plug into power supply and turn on, the charging
LED’s on the lamp will ash green to show that charging has commenced.
4.2. The number of green lights ashing indicate the level of charge
4.3. When the battery has fully charged all the LED’s will show steady green.
4.4. Direct the lens away from your eyes before switching on.
4.5. Toggle the lamp between light levels using the ON/OFF switch.
4.6. The lamp may be suspended by the hook or attached to any ferrous surface by using the magnet.
4.7. When the light is hanging from the hook it can be rotated through 360° for more precise positioning.
4.8. Separate the top and bottom sections by pulling apart. When attached to a ferrous surface, using the base magnet, the lamp can
be rotated to shine in any direction.
LED360CM | Issue:1 - 31/03/16
Original Language Version
© Jack Sealey Limited
To Next Page
Loading...