Sealey SMS02 - Operation Guide; Clamp Work Piece; Adjust Work Piece; Perform Cutting

angle grinder. When using M6 or M8 screws,
use the plastic rings on the holder rst. (g.3.)
4.6. Adjust the adjusting screws (7) & (13) to ensure
that the cutting blade is vertical to the base
and that the angle grinder is xed securely.
4.7. Press down the handle and check the position
of cutting blade, it should be within the cutting hole
of the base. If not, loosen the screws (4) and
adjust the position of the stand accordingly.
4.8. Fix the protective guard. (g.4.)
4.9. Run the grinder for a few seconds, switch off.
4.10. Check that all screws, nuts and bolts are
tight.
5. OPERATION
5.1. Clamp the work piece.
5.1.1. Rotate the screw knob (18) and loosen the
clamp (23). Put work piece in the clamp and then
tighten the screw to hold the work piece securely.
5.2. Adjust the position and angle of the work piece.
5.2.1. Loosen the screws (25) to adjust the position
and angle of the clamp (24). Tighten the screws
after the position has been adjusted. Ensure that
the work piece is in the centre of the cutting disc.
5.3. Cutting.
5.3.1. Switch on the angle grinder and press down
handle (10) to cut the work piece with the
angle grinder.
5.3.2. Start cutting with slight force and apply even force
during cutting.
g.2
g.3
g.4
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500 01284 703534 sales@sealey.co.uk www.sealey.co.uk
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
SMS02 | Issue:2 (5) 12/06/18
Original Language Version
© Jack Sealey Limited