Sealey SSCL1.V2 - Page 13

10. PRIOR TO USE
10.1. The conformity of the assembly must be veried by the site safety manager appointed by the company director.
10.2. The following elements will be veried:
• The supports.
• The assembly.
• The environment.
• The brakes.
• Wedging systems (to make up for local levelling defects).
10.3. The information in the instructions a󰀩xed to the base MUST be adhered to.
11. OPERATION
11.1. These instructions do not replace the regulations in force which must be observed.
• It is important to respect the admissible loads on the bases and the structure.
• Horizontal forces must not exceed 30kg.
• Maximum wind with stabilisers = 45km/h.
11.2. Working area:
• Keep away from bare current-carrying conductors.
• Ensure that access to equipment is prohibited in areas which are accessible to the public.
• Mark out the installation area if it is to be accessed by machinery, vehicles, etc.
• Make sure that there are no aerial obstacles in the manoeuvring area.
• Provide a bearing race on soft terrain.
11.3. The following are prohibited:
• Using a gibbet (manual included) positioned on the exterior of the sca󰀨olding.
• Covering mobile sca󰀨olding even partially.
• Increasing the height beyond the authorised level.
• Using components other than those provided and described in the parts list.
• Using the sca󰀨olding without its stabilisers.
g.27
g.29
g.28
Original Language Version
© Jack Sealey Limited
SSCL1.V2, SSCL3, SSCL4 Issue:4 28/06/21