Sealey SSCL1.V2 - Page 15

14.2. MAINTENANCE
14.2.1. Keep parts clean and safety equipment in good working order.
14.2.2. Replace or clean all plates or stickers providing instructions for use and safety information.
14.3. VERIFICATION:
14.3.1. The statutory verications (provided for in the order of 21 December 2004) are broken down as follows:
14.3.2. Verication prior to the service launch on each installation site:
- prior to initial use,
- in the event of dismantling following by reassembly of the sca󰀨olding,
- following a change to the usage, atmospheric or environmental conditions which could a󰀨ect safety when using the sca󰀨olding,
- following an interruption in usage for at least one month.
14.3.3. This verication includes an examination of suitability, assembly and installation and an examination of the general condition of the
facilities. The traceability of this verication will be recorded in the establishment’s safety register.
14.4. DAILY VERIFICATION
14.4.1. This consists of examining the general condition of the facilities.
14.4.2. The traceability of this verication is recorded in a sheet provided on the access hatch.
14.5. QUARTERLY VERIFICATION
14.5.1. Since the scope of this verication in the case of mobile sca󰀨olding is comparable to that of the daily verication, a verication carried
out at least once every 3 months is recorded in the establishment’s safety register.
NOTE: These verications may only be carried out by members of sta󰀨 in possession of a certicate of competency issued by the head of the
establishment with the reference “Verier and User”.
15. DISMANTLING & FOLDING
15.1. PRIOR TO DISMANTLING:
15.1.1. Ensure that the sca󰀨olding is stable:
Brake wheels blocked.
Stabilisers correctly positioned, etc.
15.1.2. Use ropes to handle elements if necessary.
15.2. PRIOR TO HANDLING:
15.2.1. Replace the pins and stoppers on the elements concerned.
15.2.2. Isolate the damaged components to be replaced.
15.3. DURING DISMANTLING:
15.3.1. Follow the assembly procedure in the reverse order.
15.3.2. Follow the instructions below for the folding base:
g.32
Original Language Version
© Jack Sealey Limited
SSCL1.V2, SSCL3, SSCL4 Issue:4 28/06/21