Operation
Variable luggage compartment
floor
Fig. 130
Variable luggage compartment floor:
raised position;
lowered position.
Fig. 131
Variable luggage compartment floor:
inclined position.
Variable floor in high position
●
To move from the low position to the high
position, lift the floor using the handle
›››
Fig. 130
1
, and pull it back until the front
of the floor has fully passed the supports
›››
Fig. 130
2
.
●
Move the floor forward over the supports as
far as the rear seat backrest and then lower
the floor with the handle
1
.
Variable floor in low position
●
To move from the high position to the low
position, lift the floor using the handle
›››
Fig. 130
1
, and pull it back until the front
of the floor has fully passed the supports
›››
Fig. 130
2
.
●
Now let the front part fall to the floor and
slide the floor forwards as far as the rear seat
backrest; lower the floor at the same time
with the handle
1
.
Variable floor in the tilted position
When the variable floor is tilted you can ac-
cess the spare wheel or anti-puncture kit
area.
●
Lift the variable floor in the high position us-
ing handle
›››
Fig. 130
1
, pull it up and push
it towards the backrest of the rear seats until
it folds along the hinge line and the movable
part of the floor is resting on itself.
●
Rest the floor on its housings
›››
Fig. 131 (ar-
rows).
Variable floor with folded seats
●
To move from the high position to the low
position, lift the floor using the handle
›››
Fig. 130
1
and pull it back a little.
●
Push the variable floor towards the folded
rear seats with the handle
1
using some
downward pressure so that the moving part
of the floor is flush with the backs of the rear
seats.
WARNING
●
Always secure objects, even when the
luggage compartment floor is properly lif-
ted.
●
Only objects that do not protrude more
than 2/3 the height of the floor may be car-
ried between the rear seat and the raised
luggage compartment floor.
142
To Next Page
Loading...
