Seat ATECA 2024 - Front Centre Armrest

98
Seats and headrests
●
Press the memory button in which to store the
settings within approx. 10 seconds. An audible
signal confirms that they have been saved.
Save the settings of the front passenger ex-
terior mirrors for reversing.
●
Apply the electronic parking brake.
●
Set the gearbox to the neutral position.
●
Switch the ignition on.
●
Press whichever memory button you want.
●
Select reverse gear.
●
Adjust the front passenger exterior mirror so
that you can see, for example, the kerb edge
well.
●
The set position for the mirrors is automati-
cally saved and assigned to the key with which
you unlocked the vehicle.
Activating the settings
●
With the vehicle stopped and the ignition
switched on, press and hold the correspond-
ing memory button until the saved position is
reached.
●
OR: With the ignition switched o and the
driver's door open, briefly press the corre-
sponding button.
The front passenger side exterior mirror auto-
matically changes from the position stored for
reversing as soon as the vehicle moves forward
at a speed of at least 15km/h (10mph) or when
the gear selection lever is changed to a position
other than R ›››page111.
Initialising the seat position memory
If, for example, the driver seat has been re-
placed, the position memory system must be
restarted.
Restarting deletes all memories and assign-
ments of seats with memory functions. The
memory keys can then be programmed again.
●
Open the driver's door and do not get into the
vehicle.
●
Change the seat settings from outside.
●
Tilt the backrest fully forward.
●
Release the control to adjust the inclination
and press it again until an audible signal
sounds.
Easy Entry function
Depending on the equipment, the Easy Entry
function makes it easier for the driver to enter
and exit by moving the seat forwards or back-
wards respectively.
The function is activated in the seat menu of
the infotainment system. The function can only
be activated if the SEAT CONNECT services are
available.
WARNING
Only set the memory function when the vehi-
cle is stationary.
Note
If the driver's door is opened approx. 10 mi-
nutes after the vehicle was unlocked or later,
the driver seat and the exterior mirrors do not
move automatically.
Front centre armrest
Fig.77 Front centre armrest
To raise the armrest, pull it fully up in the direc-
tion of the arrow ›››Fig.77 up or step by step
depending on the desired opening.
To lower the armrest, first lift it to its highest
position. Then lower it down.